H2 SX ECU Damage?
- SUKE
- New Member

- Posts: 7
- Joined: Mon May 12, 2025 11:48 pm
- Location: Japan
- Bike(s): H2SX 2018 metallic carbon gray
H2 SX ECU Damage?
I know it was a foolish mistake, and I really regret it.
I accidentally connected the wires for the cruise control switch and the clutch switch (the switch mounted on the clutch holder) together.
After that, the neutral (N) light stays on all the time, and the gear position indicator no longer displays the correct gear.
Could this have damaged the ECU? Would replacing the ECU be necessary?
Sorry if my English isn't perfect—I used Google Translate.
I have already replaced the gear position sensor and the relay box, but the problem is still the same.
I accidentally connected the wires for the cruise control switch and the clutch switch (the switch mounted on the clutch holder) together.
After that, the neutral (N) light stays on all the time, and the gear position indicator no longer displays the correct gear.
Could this have damaged the ECU? Would replacing the ECU be necessary?
Sorry if my English isn't perfect—I used Google Translate.
I have already replaced the gear position sensor and the relay box, but the problem is still the same.
0 x
- unknownbiker
- Chirp-Chirp!

- Posts: 352
- Joined: Thu Apr 02, 2020 10:21 pm
- Location: Canada East
- Bike(s): H2 SX
- x 557
- x 93
- SUKE
- New Member

- Posts: 7
- Joined: Mon May 12, 2025 11:48 pm
- Location: Japan
- Bike(s): H2SX 2018 metallic carbon gray
Re: H2 SX ECU Damage?
The check engine light is not on, and I connected a diagnostic scanner just to be sure, but no error codes were found.
I also took the bike to a shop and had it checked with KVCS, but there were still no fault codes.
We even tried resetting/initializing the system using KVCS, but it made no difference.
I also took the bike to a shop and had it checked with KVCS, but there were still no fault codes.
We even tried resetting/initializing the system using KVCS, but it made no difference.
0 x
Re: H2 SX ECU Damage?
At the risk of sounding silly, have you tried disconnecting the battery for awhile?
0 x
- SUKE
- New Member

- Posts: 7
- Joined: Mon May 12, 2025 11:48 pm
- Location: Japan
- Bike(s): H2SX 2018 metallic carbon gray
Re: H2 SX ECU Damage?
I also thought disconnecting the battery might reset the system, so I left the battery disconnected for about a week.
Unfortunately, it didn't make any difference. The problem is exactly the same.
Unfortunately, it didn't make any difference. The problem is exactly the same.
0 x
- danham
- Supercharged!

- Posts: 597
- Joined: Sat Mar 02, 2019 6:40 pm
- Location: Cape Cod, MA USA
- Bike(s): 2018 SE
- x 196
- x 211
Re: H2 SX ECU Damage?
You might try disconnecting the two switches and see if the gear indicator works. If yes, this could mean a problem with the switches.
-dan
-dan
1 x
2018 H2 SX SE
Sprint P08 filter
Skene P3 rear LEDs
Skene Photon Blaster front LEDs
Woodcraft frame sliders
Nelson Rigg tail bag
DID 525ZVM-X2 chain
- SUKE
- New Member

- Posts: 7
- Joined: Mon May 12, 2025 11:48 pm
- Location: Japan
- Bike(s): H2SX 2018 metallic carbon gray
Re: H2 SX ECU Damage?
I also disconnected the gear position sensor and the relay box (the one located above the headlight inside the upper fairing) to see if the neutral light would turn off.
There was no change at all. The problem is exactly the same.
Could the side stand switch also be causing this problem?
There was no change at all. The problem is exactly the same.
Could the side stand switch also be causing this problem?
0 x
- danham
- Supercharged!

- Posts: 597
- Joined: Sat Mar 02, 2019 6:40 pm
- Location: Cape Cod, MA USA
- Bike(s): 2018 SE
- x 196
- x 211
Re: H2 SX ECU Damage?
I’m on a small screen right now, so can’t look, but if you examine the wiring diagram posted elsewhere in this forum, you may get some ideas from that. Good luck!
-dan
-dan
0 x
2018 H2 SX SE
Sprint P08 filter
Skene P3 rear LEDs
Skene Photon Blaster front LEDs
Woodcraft frame sliders
Nelson Rigg tail bag
DID 525ZVM-X2 chain
- SUKE
- New Member

- Posts: 7
- Joined: Mon May 12, 2025 11:48 pm
- Location: Japan
- Bike(s): H2SX 2018 metallic carbon gray
Re: H2 SX ECU Damage?
For now, I'm going to try replacing the side stand switch and see if that fixes the problem.
0 x
Who is online
Users browsing this forum: Bing [Bot] and 6 guests

