Handlebar Adjustment Spacers

[roadczar]

10 minute installation. Quality built as expected from BEET Japan. Makes bigger difference than you would expect. At Least for my 5'10" height.
Gives about 5mm fore / aft adjustability as well. Had to angle my brake lever down about 5mm to clear upper at full left lock.

[roadczar]

[HouTexH2SX]

I wonder if you could get a couple more and some longer bolts and end up with 15mm? That's getting closer to the 3/4" total that I think would be helpful.

No problems with the cable lengths?

[HaraldB]

Great!
Looking forward getting my parts out of customs.

[roadczar]

You may be able to squeeze another spacer in there, but it will be very close. Also, you will be losing more clamping surface for the clip-on.

I wonder if you could get a couple more and some longer bolts and end up with 15mm? That's getting closer to the 3/4" total that I think would be helpful.

No problems with the cable lengths?

[silverr1]

Can someone do a photocopy of this on a copier to scale? I would like to use it as a template and see if can do a few tests ones on a 3D printer.

Play with thickness and angles.

[silverr1]

Anyone able to help out with the dimensions of the spacer?

[HaraldB]

Send me your email adress

[HouTexH2SX]

You may be able to squeeze another spacer in there, but it will be very close. Also, you will be losing more clamping surface for the clip-on.

I wonder if you could get a couple more and some longer bolts and end up with 15mm? That's getting closer to the 3/4" total that I think would be helpful.

No problems with the cable lengths?

You're right about the clamping space--no way to put a third 5mm spacer in.

For those that have installed these would you recommend them? 0.4" of additional rise sure doesn't seem like much.

[roadczar]

I like it (10mm). Together with Knight Design lowered pegs it made a difference you can definitely feel.