H2 SX/SX SE recall

Post by **Kwee** » Sat Sep 08, 2018 4:40 pm

Just received my recall right now

Post by **Kwee** » Sun Sep 09, 2018 12:14 pm

Pictures take from Facebook, crédit David Henshaw

The new part is on top

Post by **FJR919** » Sun Sep 09, 2018 3:31 pm

Just entered my VIN at the Kawasaki site. No recalls out for my bike.

Post by **HouTexH2SX** » Sun Sep 09, 2018 3:38 pm

Kwee wrote: Sun Sep 09, 2018 12:14 pm Pictures take from Facebook, crédit David Henshaw

The new part is on top

Yep, they just welded the front side also to close the gap and eliminate water intrusion that was causing the pin to rust and fail. Easy to check to see if your bike needs this.

Post by **HaraldB** » Sun Sep 09, 2018 4:43 pm

FJR919 wrote: Sun Sep 09, 2018 3:31 pm Just entered my VIN at the Kawasaki site. No recalls out for my bike.

Have you checked your bikes VIN in the related Service Info?

See post #89

Post by **HouTexH2SX** » Sun Sep 09, 2018 4:53 pm

HaraldB wrote: Sun Sep 09, 2018 4:43 pm
FJR919 wrote: Sun Sep 09, 2018 3:31 pm Just entered my VIN at the Kawasaki site. No recalls out for my bike.

Have you checked your bikes VIN in the related Service Info?

See post #89

If your pin is not welded on the front side you are part of the recall whether your VIN is listed or not. I would not assume anything else.

Post by **XcelleraThor** » Sun Sep 09, 2018 5:13 pm

Kwee wrote: Sun Sep 09, 2018 12:14 pm Pictures take from Facebook, crédit David Henshaw

The new part is on top

Thanks man for posting a pic of the replacement and confirming! HouTexH2SX was right when asuming the front side gap around the peg was to blame!

Post by **XcelleraThor** » Sun Sep 09, 2018 5:29 pm

HouTexH2SX wrote: Fri Sep 07, 2018 9:07 pm The picture of the failed pin that roadczar posted looks like some rusting of the pin itself may have caused the failure. Mine is welded on the backside but I'm still nervous--probably needs to be welded on the frontside as well to prevent water intrusion.

Yep! You were right!

Post by **FJR919** » Sun Sep 09, 2018 6:54 pm

Thanks for the additional info. Like the rest of you the pin appears welded on the back and not the front (no big surprise that mine is no different). Oh well, something else to do when I put the Vandemon system in.

Post by **vcyclenut** » Mon Sep 10, 2018 3:13 pm

anyone n the USA get a notice?

my stand is already off , took it off when installing the exhaust

my pin is not welded on the front side so I think it would be in the recall

H2 SX/SX SE recall

Re: H2 SX/SX SE recall

Re: H2 SX/SX SE recall

Re: H2 SX/SX SE recall

Re: H2 SX/SX SE recall

Re: H2 SX/SX SE recall

Re: H2 SX/SX SE recall

Re: H2 SX/SX SE recall

Re: H2 SX/SX SE recall

Re: H2 SX/SX SE recall

Re: H2 SX/SX SE recall

Who is online