Error code help please

Bike aesthetic/mechanical/electrical modifications and general wrenching advice.
Post Reply
User avatar
Palmer812
Boost Engaged

Boost Engaged
Posts: 64
Joined: Fri Jul 27, 2018 4:32 pm
Location: USA. North Carolina
Bike(s): 2015 zx14r. 2018 klx250

Error code help please

Post by Palmer812 » Sun Aug 18, 2019 9:53 pm

My check engine light came on after washing the bike today. The error code is 69. Can somebody tell me what that is? I found the shop manual pdf on here but it’s too big to download on my iPad and I downloaded the mega view app but I need to access my email for the registration and don’t have email access right now. Thanks.
0 x
Top
User avatar
Burmashave
Supercharged!

Supercharged!
Posts: 542
Joined: Mon Jul 16, 2018 8:59 pm
Location: USA
Bike(s): H2 SX SE
x 16
x 11

Re: Error code help please

Post by Burmashave » Sun Aug 18, 2019 10:02 pm

From page 17-14 of the manual:

"Knock sensor malfunction, wiring open or short"

Service for the knock sensor (removal and check) is on page 17-108. It's located in front of the intake duct where the the air filter is.
0 x
Top
User avatar
Palmer812
Boost Engaged

Boost Engaged
Posts: 64
Joined: Fri Jul 27, 2018 4:32 pm
Location: USA. North Carolina
Bike(s): 2015 zx14r. 2018 klx250

Re: Error code help please

Post by Palmer812 » Sun Aug 18, 2019 11:10 pm

Thanks. Must have been too wet from the rain then me washing it. I did the ride for 5 minutes over 25 mph 3 times and it cleared. Thanks again.
0 x
Top
User avatar
cOoTeR
Supercharged!

Supercharged!
Posts: 1105
Joined: Fri Dec 15, 2017 3:40 am
Location: United States
x 2

Re: Error code help please

Post by cOoTeR » Mon Aug 19, 2019 12:13 pm

Might have gotten water into the gas.
0 x
Stock with airfilter 164whp 84ft.lbs
De-restricted + tuned 213whp 97ft.lbs
Full vandemon exhaust with tune 221whp 99ft.lbs
On Race Fuel 233whp 103ft.lbs
Top
User avatar
keith zx
Accelerating

Accelerating
Posts: 188
Joined: Fri Feb 08, 2019 12:33 pm
Location: south shields uk
Bike(s): sx1000
x 1

Re: Error code help please

Post by keith zx » Mon Aug 19, 2019 1:01 pm

that's one of the reasons why I never wash my bike ...
0 x
Top
User avatar
JustinP
Accelerating

Accelerating
Posts: 121
Joined: Sat Jul 13, 2019 8:22 pm
Location: Greeley, CO
Bike(s): 2018 H2 SX SE, 2008 Hayabusa, 2004 FJR
x 1

Re: Error code help please

Post by JustinP » Mon Aug 19, 2019 2:18 pm

Not saying you did, but never wash your bike with high pressure. Low pressure is fine. Water won't hurt a bike unless forced into seals and sensors.
0 x
Top
Post Reply

Who is online

Users browsing this forum: BonnyH-019 and 49 guests