Length of H2SX Woodcraft frame slider

Bike aesthetic/mechanical/electrical modifications and general wrenching advice.
Post Reply
User avatar
Prof J
Accelerating
Accelerating
Posts: 346
Joined: May 29th, 2019
Location: Oregon, USA
Bike(s): '19 SE +
x 30
x 41

Length of H2SX Woodcraft frame slider

Post by Prof J » Wed Jun 12, 2019 9:50 pm


Can't find the dimension on vcyclenut's web site.

Not counting the threaded shaft, can someone please tell me the length of the H2SX Woodcraft frame sliders, both left and right side?

Thank you.
0 x

User avatar
stk0308
Low Boost
Low Boost
Posts: 164
Joined: Feb 14th, 2018
Location: St Louis
Bike(s): '01 YZ426f, '08 Sprint ST, '16 Street Triple R, '18 H2 SX SE
x 229
x 62

Re: Length of H2SX Woodcraft frame slider

Post by stk0308 » Fri Jun 14, 2019 2:36 am


I don't know what threaded shaft you think is involved. It attaches via a through bolt that replaces the upper engine(head really) to frame mount bolt. The frame sliders as installed are:
left: 3.5 inches long
right: 3 inches long

Measured from the frame to the end of the delrin slider that would impact the ground.
0 x

Motorcycling is not, of itself, inherently dangerous. It is, however, extremely unforgiving of inattention, ignorance, incompetence, or stupidity

User avatar
Prof J
Accelerating
Accelerating
Posts: 346
Joined: May 29th, 2019
Location: Oregon, USA
Bike(s): '19 SE +
x 30
x 41

Re: Length of H2SX Woodcraft frame slider

Post by Prof J » Fri Jun 14, 2019 3:15 am


stk0308 wrote:
Fri Jun 14, 2019 2:36 am
I don't know what threaded shaft you think is involved. It attaches via a through bolt that replaces the upper engine(head really) to frame mount bolt. The frame sliders as installed are:
left: 3.5 inches long
right: 3 inches long

Measured from the frame to the end of the delrin slider that would impact the ground.
stk0308, thanks. The photo on the website seemed to show the puck threaded bolt being constructed to thread into the frame.

Got it, it will be an engine mounting orifice.
0 x

User avatar
Prof J
Accelerating
Accelerating
Posts: 346
Joined: May 29th, 2019
Location: Oregon, USA
Bike(s): '19 SE +
x 30
x 41

Re: Length of H2SX Woodcraft frame slider

Post by Prof J » Fri Jun 14, 2019 3:16 am


Prof J wrote:
Fri Jun 14, 2019 3:15 am
stk0308 wrote:
Fri Jun 14, 2019 2:36 am
I don't know what threaded shaft you think is involved. It attaches via a through bolt that replaces the upper engine(head really) to frame mount bolt. The frame sliders as installed are:
left: 3.5 inches long
right: 3 inches long

Measured from the frame to the end of the delrin slider that would impact the ground.
stk0308, thanks for the info. The photo on the website seemed to show the puck threaded bolt being constructed to thread into the frame.

Got it, it will be an engine mounting orifice.
0 x

Post Reply
meble kuchenne na wymiar warszawa cennik

Who is online

Users browsing this forum: theoldone and 23 guests